The DRV8835 dual motor driver is a small size breakout board that can deliver 1.2A per channel continously to a pair of DC motors with an operating voltage range from 2 to 11 V. The Pololu DRV8835 is protected against reverse-voltage, under-voltage, over-current and over-temperature. It is also pin compatible with standard breadboard.
Texas Instruments’ DRV8835 is a tiny dual H-bridge motor driver IC that can be used for bidirectional control of two brushed DC motors at 2 to 11 V. It can supply up to about 1.2 A per channel continuously and can tolerate peak currents up to 1.5 A per channel for a few seconds, making it an ideal driver for small motors that run on relatively low voltages. The DRV8835 is a great IC, but its small, leadless package makes it difficult for the typical student or hobbyist to use; our breakout board gives this driver the form factor of a 14-pin DIP package, which makes it easy to use with standard solderless breadboards and 0.1″ perfboards. Since this board is a carrier for the DRV8835, we recommend careful reading of the DRV8835 datasheet (208k pdf). The board ships populated with SMD components, including the DRV8835, and adds a FET for reverse battery protection.
This board is very similar to our DRV8833 dual motor driver carrier in operating voltage range and continuous current rating, but the DRV8835 has a lower minimum operating voltage, offers an extra control interface mode, and is 0.1″ smaller in each dimension. The DRV8833 has a higher peak current rating (2 A per channel vs 1.5 A), optional built-in current-limiting, and no need for externally supplied logic voltage.
- Motor driver: DRV8835
- Operate 2 DC motors
- Minimum operating voltage: 2.0 V
- Maximum operating voltage: 11 V
- Continuous output current per channel: 1.2 A
- Peak output current per channel: 1.5 A
- Reverse voltage protection: Yes
- 1x DRV8835 motor controller
- 1x 16x1 2.54 mm male headers
|Dimensions L x W x H||1.8 cm x 1 cm|
Pololu DRV8835 Dual Brushed DC Motor Controller
- The Pololu DRV8835 Dual Motor Driver can operate 2 DC motors at a voltage between 2 and 11 V.
- 3.85€ Euro EUR 154.51 Left For Free Shipping
- 5 or more 3.34€ Euro